- Density, g/cm³
- 1
- Drying Time, h
- ~24
- Solid Content, %
- 100
- Packing
- A: 12 kg + B: 6 kg (total 18 kg)
Technical Specifications
| Parameter | Value |
|---|---|
| Density, g/cm³ | 1 |
| Drying Time, h | ~24 |
| Solid Content, % | 100 |
| Packing | A: 12 kg + B: 6 kg (total 18 kg) |
| Application Equipment | Applied with an injection machine |
| Viscosity, cP | 200-300 |
| Mixing Ratio, % | A/B: 2/1 |
| Bending Strength, N/mm² | 25 |
| Compressive Strength, N/mm² | 65 |
Product Description
A two-component, epoxy-based, solvent-free injection product.
Application Areas
- In reinforced concrete and prefabricated building elements, and in stone and solid brick structures
- Used to strengthen the structure by filling static cracks in all kinds of engineering structures such as motorways, bridges, tunnels and metro lines.
Advantages
- Excellent adhesion to concrete and steel surfaces.
- Can be applied very easily with simple attachments fitted to the front of a hand drill.
- Does not shrink.
- Can be applied in dry and slightly damp environments.
- After full curing, it has higher compressive and tensile strength than concrete.
Application
The prepared mixture is transferred to the injection pump and injected into the crack through injection packers. Injection should be carried out from the bottom upwards, and care must be taken that the injection resin does not flow out of the visible front surface of the crack. Injection should be continued until no pressure loss is observed on the manometer, and care must be taken that the resin fully penetrates even hairline cracks. In special cases (wide cracks in floors, etc.), the application can be carried out by pouring.
Packaging & storage
Packaging
A: 12 kg + B: 6 kg (total 18 kg)
Where it is used
Documents
Technical data sheet (TDS)
Review the recorded specifications, packaging and storage information.
View technical data sheet ↗Safety & lot documents
Request the current SDS and the certificate of analysis (CoA) for the lot you are evaluating.
SDS available on request.
Request Sample
Product Information
Two-Component, Epoxy-Based, Low-Viscosity Injection Resin Typical specifications: Density, g/cm³: 1; Drying Time, h: ~24; Solid Content, %: 100. KORKİMYA supplies POX 088 in A: 12 kg + B: 6 kg (total 18 kg).
A two-component, epoxy-based, solvent-free injection product.
Two-Component, Epoxy-Based, Low-Viscosity Injection Resin
- Category
- INJECTION MATERIALS
Frequently asked questions
What are the key specifications of POX 088?
The recorded supply specification for POX 088 includes Density, g/cm³: 1; Drying Time, h: ~24; Solid Content, %: 100; Packing: A: 12 kg + B: 6 kg (total 18 kg); Application Equipment: Applied with an injection machine. The full table is listed on this page.
How is POX 088 packaged and stored?
Packaging: A: 12 kg + B: 6 kg (total 18 kg).
Is POX 088 KKDİK registered, and which documents are available?
Yes. POX 088 supplied by KORKİMYA is KKDİK registered. The SDS and the certificate of analysis (CoA) for the lot you are evaluating are available on request through this page.
Related Products
Last updated: 10/11/2026
MSDS Available on Request · Export Registered · korkimya.com